Plastikov v3 Rail Kit - Stainless Steel
- Compatible with Plastikov v0.9 and later versions
- Machined from solid 17-4PH Stainless Steel
- Drop-in ready, no hand-fitting required
- Includes all necessary hardware and hex key
- Open screw holes in receiver to .0995"
- Use one of our Drill Bit Kits to properly size the holes in your 3D-printed frame!
- Start all screws with fingers to avoid cross-threading
- The documentation included with the downloaded files contains installation and troubleshooting notes
- (1) Left Rail
- (1) Right Rail
- (1) 1.5mm Hex Key
- (16) M2.5 x 8mm BHCS
*Note: This rail design was designed, tested, and approved by Ivanthetroll. Should you need any assistance, please refer to the documentation included with the files or contact us!