Plastikov Drill Bit
Use this drill bit kit to properly size the rail screw holes in 3D printed Plastikov lower receiver.
This kit is only guaranteed to work with Riptide Rails' rail kits.
Please note that the Plastikov drill bit is the same as the G17/G19 rear rail drill bit and the SD9/SR9/Mac Daddy drill bit is the same as the G17/G19 front pin drill bit.
#39 Drill Specs
|Drill Bit Size (Wire) ||#39 |
|Drill Bit Size (Decimal Inch) ||0.0995 |
|Drill Point Angle ||118 |
|Drill Bit Material ||High Speed Steel |
|Drill Bit Finish/Coating ||Oxide |
|Flute Type ||Spiral |
|Cutting Direction ||Right Hand |
|Shank Type ||Straight |
|Coolant Through ||No |
|Flute Length (Inch) ||1-3/8 |
|Overall Length (Inch) ||2-3/8 |
|Point Type ||Standard |
|Shank Diameter (Decimal Inch) ||0.0995 |
|Spiral Type ||Regular Spiral |
|Web Configuration ||Tapered |
|Web Thinning ||Web-Thinned |
|Drill Bit Grade ||General Purpose |
*Note: Riptide Rails' pin diameters may differ from the developers' original design but are still compatible with the original 3D-printed design.