Mac Daddy Feed Ramp - Aluminum
- Compatible with the FMDA Mac Daddy 3D-printed lower receiver
- Machined from 6061 aluminum
*Due to loose tolerances in some manufacturers' upper receivers, some hand fitment may be required.
- Be sure to remove 100% of any support material from the feed ramp pocket before installing
- Open feed ramp pin hole in frame 0.124"
- Find drill bits here
- (1) Mac Daddy Feed Ramp - Aluminum
- (1) 1/8" Solid Pin**
- (1) Riptide Rails Sticker
**Note: Riptide Rails' pin diameters may differ from the developers' original design but are still compatible with the original 3D-printed design.