G19 DIY Rail Kit - Aluminum
Uh oh! This item is currently out of stock. You can purchase this kit from Ghost Guns' by clicking here.
Please donate to the developers!
- Compatible with FMDA G19 with DIY rail system and the Silverhawk Arms SH-19
- Drop-in ready
- Machined from 6061 aluminum
- Includes all necessary hardware and hex key (one free hex key per screw type per order)
- Front Rail Pin made in-house to ensure a proper fit. No additional work required on your end!
- The FMDA G19 is designed to use a G26 locking block. If you have a G19 locking block, you will have to trim the front rail block or the G19 locking block to allow proper clearance between the two parts
- Open screw holes in frame to .0995"
- Open front rail block pin hole in frame to 0.124"
- Find drill bits here: https://riptiderails.com/g17-g19-drill-bitshttps://riptiderails.com/g17-g19-drill-bits
- Start all screws with fingers to avoid cross-threading
- (1) Front Rail Block
- (1) Rear Left Rail
- (1) Rear Right Rail
- (1) 1.5mm Hex Key
- (4) M2.5 x 7mm BHCS
- (1) 1/8" x 1-1/16" Solid Pin
- (1) 3D-Printed RailBlock
*Note: Riptide Rails' pin diameters may differ from the developers' original design but are still compatible with the original 3D-printed design.