G17 DIY Rail Kit - Aluminum
Riptide Rails' kits are ready to use and easy to install! The screws are already ground to the recommended 7mm length and the front pin doesn't require a hammer to install!
- Compatible with FMDA G17 with DIY rail system
- Drop-in ready
- Machined from 6061 aluminum
- Includes all necessary hardware
- Ream screw holes in frame to .0995" (#40)
- Ream front rail block pin hole in frame to .125" (1/8")
- Start all screws with fingers to avoid cross-threading
- (1) Front Rail Block
- (1) Rear Left Rail
- (1) Rear Right Rail
- (4) M2.5 x 7mm BHCS (Already ground to length)
- (1) 1/8" x 1-1/16" Solid Pin (No hammering necessary)*
- (1) 3D-Printed RailBlock
*Note: Riptide Rails' pin diameters may differ from the developers' original design but are still compatible with the original 3D-printed design.