DD43.1 Rail Kit
- Compatible with the DD43.1/DD43x 3D-printed frames and variants
- Drop-in ready
- Front rail machined from 6061 aluminum
- Rear rail is 304 stainless steel
- Use one of our Drill Bit Kits to properly size the holes in your 3D-printed frame!
- To install the 2-piece rear rail, install the right-side; then the trigger housing; then the left-side, thinner rear rail. Move the rails around by hand until the holes are approximately aligned, then install the pin.
- (1) Front Rail
- (1) Rear Rail Set
- (1) Front Rail Pin
- (1) Trigger Housing Pin
*Disclaimer: This product is not manufactured, authorized, endorsed, or warranted by GLOCK. GLOCK does not warrant or represent that this product is compatible with GLOCK pistols.