DD43.1 Rail Kit - Aluminum

DD43.1 Rail Kit - Aluminum

Product Description

• Compatible with the DD43.1/DD43x 3D-printed frames and variants
• Drop-in ready
• Front and rear rails are machined from 6061 aluminum

Installation Tips

• Use one of our Drill Bit Kits to properly size the holes in your 3D-printed frame!
• To install the 2-piece rear rail, install the right-side, thicker rear rail; then the trigger housing; then the left-side, thinner rear rail. Move the rails around by hand until the holes are approximately aligned, then install the pin. The rear rails will be slightly snug if your printer has been calibrated properly.

What's Included

• (1) Front Rail
• (1) Rear Left Rail
• (1) Rear Right Rail
• (1) Front Rail Pin
• (1) Trigger Housing Pin